土壤中7种重金属和砷测定的精密度控制指标研究

通过对浙江省近700组实际土壤样品进行分析,研究了土壤中铜、铅、锌、铬、镍、镉、砷、汞7种重金属和砷测定的精密度控制指标(实验室内相对偏差和实验室间相对偏差),并与行业标准分析方法和文献进行了比较,旨在为环境监测质量控制与质量保证工作提供参考。经统计分析,建议实验室内相对偏差控制指标如下:铜,≤15%;铅,≤15%;锌,≤15%;铬,≤15%;镍,≤15%;镉,≤20%;砷,≤15%;汞,≤50%。建议实验室间相对偏差控制指标如下:铜,≤25%;铅,≤25%;锌,≤20%;铬,≤20%;镍,≤25%;镉,≤35%;砷,≤25%;汞,≤55%。     

Investigating the quantitative and qualitative status of effluent in the wastewater treatment plant in Iran Central Iron Ore

The aim of present study was to investigate the quality of the produced effluent from different units of the Iran Central Iron Ore in Bafq city and comparison of effluent with the standards. This study presents the physicochemical and biological parameters data of effluent of three Sequencing batch reactors (SBR) with a capacity of 160 m³?d^?1. Most common parameters include pH, total suspended solids (TSS), total nitrogen (TN), total phosphorus (TP), biochemical oxygen demand (BOD₅), chemical oxygen demand (COD), heavy metals, and total coliforms and fecal coliforms as biological indicators. Then, for each SBR system, the average of each parameter was determined, and results were compared with the standard recommended by the Iranian Environmental Protection Agency. Based on the results, some of the parameters, including BOD₅, COD, and TSS in the wastewater treatment plant (WWTP) effluent, are higher than the permitted amount for discharge to the surface water. Considering the BOD₅, COD, and TSS concentration in WWTPs, the treated wastewater is only suitable for agricultural and irrigation use. Therefore, wastewater produced by Iran Central Iron Ore Co. will need additional treatment to achieve standard quality of water before discharge in surface water and adsorbent well.     

Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

• Strong metal-support interaction exists on Pt/Fe₃O₄ catalysts. • Pt metal particles facilitate the formation of oxygen vacancies on Fe₃O₄. • Fe₃O₄ supports enhance the strength of CO adsorption on Pt metal particles. The self-inhibition behavior due to CO poisoning on Pt metal particles strongly impairs the performance of CO oxidation. It is an effective method to use reducible metal oxides for supporting Pt metal particles to avoid self-inhibition and to improve catalytic performance. In this work, we used in situ reductions of chloroplatinic acid on commercial Fe₃O₄ powder to prepare heterogeneous-structured Pt/Fe₃O₄ catalysts in the solution of ethylene glycol. The heterogeneous Pt/Fe₃O₄ catalysts achieved a better catalytic performance of CO oxidation compared with the Fe₃O₄ powder. The temperatures of 50% and 90% CO conversion were achieved above 260°C and 290°C at Pt/Fe₃O₄, respectively. However, they are accomplished on Fe₃O₄ at temperatures higher than 310°C. XRD, XPS, and H₂-TPR results confirmed that the metallic Pt atoms have a strong synergistic interaction with the Fe₃O₄ supports. TGA results and transient DRIFTS results proved that the Pt metal particles facilitate the release of lattice oxygen and the formation of oxygen vacancies on Fe₃O₄. The combined results of O₂-TPD and DRIFTS indicated that the activation step of oxygen molecules at surface oxygen vacancies could potentially be the rate-determining step of the catalytic CO oxidation at Pt/Fe₃O₄ catalysts. The reaction pathway involves a Pt-assisted Mars-van Krevelen (MvK) mechanism.     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

我国高速公路周边土壤重金属污染现状及研究进展

以我国高速公路周边土壤重金属为研究对象，综述了我国高速公路周边土壤重金属污染特征、影响因素、来源、环境风险及其研究进展。高速公路周边土壤主要受Pb、Cd、Cr、Cu、Zn等重金属污染，主要呈现指数分布、偏态分布和两者混合分布等特点，并且受到土地利用、风向、地形、车流量等多种因素的综合影响。土壤重金属的来源除了受成土母质等自然因素影响以外，公路交通和周边工农业活动也会对其来源产生较大影响。传统的土壤重金属评价方法主要采用单因子指数法、地累积指数法、生态风险评价法等对重金属的污染等级和环境风险进行评价。未来的研究应将重金属形态分析、空间和地统计分析、重金属稳定同位素示踪和源解析模型以及预测模型等多种手段相结合，开展高速公路周边土壤重金属的污染特征、时空分布、来源及预测预警研究等，为我国高速公路沿线工农业生产布局及其土壤重金属污染防控提供科学依据和决策支撑。     

冷轧浓油废水预处理设施的设计与运行

就宝钢不锈钢有限公司配套建设的冷轧浓油废水处理工程的浓油废水预处理设施的设计与运行进行了介绍和分析,可作为相似工程中的借鉴和参考。     

电动技术去除城市污泥重金属的试验研究

采用直流电解污泥反应器,在20V稳定电压作用下进行试验,通过采用蒸馏水和添加电解质的蒸馏水为电极液的两套反应器进行对比试验,测定电动过程中污泥工作区pH值、电压降分布和重金属浓度变化情况,研究电动去除城市污泥中重金属过程中不同污泥工作区的污泥性质的变化及重金属去除效果,并确定了能有效去除污泥中高浓度重金属的有效电动工作区。     

中国主要水系沉积物中重金属分布特征及来源分析

本文简要综述了中国主要水系沉积物中重金属(Cd、As、Zn、Pb、Cu、Hg、Cr)的分布特征,系统讨论了区域城市化进程对水环境的影响,分析了重金属污染特征及其来源,并采用潜在生态风险指数法评价了中国主要水系沉积物中重金属的潜在生态危害系数和危害指数。结果显示,中国主要水系表层沉积物中重金属的复合污染状况评价结果是:Cd>Hg>Pb>As>Zn>Cr>Cu。其中,Cd元素的Eir值介于41.25～1755.00之间,属于轻微到极强生态危害,其中大部分样点属于强至极强生态危害。Hg元素的Eir值介于115.29～470.83之间,属于强到极强生态危害,其中大部分样点属于很强至极强生态危害。地区对比而言,综合污染状况以海河和珠江较为显著,长江污染最轻。就其来源来讲,海河流域和珠江流域污染来源主要为工业污染,长江和黄河主要是流域岩石风化和土壤侵蚀。     

重庆城口地区下寒武统黑色岩系重金属富集特征及其生态环境效应

重庆城口地区广泛发育有下寒武统黑色岩系。测定了城口地区下寒武统黑色岩系中多金属富集层、黑色岩系岩石及其风化土壤、硅质岩样品中Cr、Co、Ni、Cu、Zn、As、Cd、Sb、Pb含量。结果表明多金属富集层中重金属相对比较富集,其中Cd、Zn、As的富集程度较高,富集系数平均分别为119.67,10.73,7.30。运用地质累积指数法和生态危害指数法评价了重金属的潜在生态环境效应,其中Cd、As的生态危害较大,黑色岩系尤其以多金属富集最为明显,在未来的研究中关注多金属富集层中Cd、As的生态环境效应。     

深圳湾海域沉积物中酸可挥发性硫化物与重金属生态风险评价

测定了深圳湾海域10个站点表层沉积物中的AVS、TOC和同步浸提重金属(SEM)的含量,对AVS、SEM的平面分布及AVS与SEM和TOC的相互关系进行了分析。结果表明:深圳湾海域表层沉积物AVS含量范围为0.06～7.41μmol/g,平均值为2.51μmol/g;SEM含量范围为0.71～5.15μmol/g,平均值为3.06μmol/g;AVS与SEM的平面分布较一致,呈从湾顶到湾中向湾外逐渐递减的明显趋势。调查海域AVS与SEM和TOC间具有良好的线性相关性,大多数站点∑SEM-AVS的差值均0<(∑SEM-AVS)<5,说明该海域可能存在重金属的中等毒性生态风险。